As we know, Polk soundbars are the best for producing enhanced audio, but adding a subwoofer enhances your listening experience to the next level. You can pair the Polk soundbar to a subwoofer automatically just by turning on both devices. If it fails, you can press certain buttons on the soundbar and subwoofer to pair the devices. This guide will walk you through the steps to connect the Polk Soundbar to a subwoofer.
Steps to Automatically Pair Polk Soundbar to Subwoofer
If you have a newer Polk soundbar model, refer to the steps below to connect the soundbar and subwoofer.
1. Activate Soundbar and Subwoofer: Begin by plugging both devices into power and turning them on individually.
2. Signal Pairing Mode on Subwoofer: Many subwoofers, once powered on, will initiate a pairing mode. If not, locate the subwoofer’s pairing button and press it to signal readiness.
3. Wait for Confirmation: Observe the indicator lights on both devices. A steady light generally confirms a successful connection.
Once connected, listen to the audio via your soundbar and subwoofer.
Steps to Manually Pair Polk Soundbar to Subwoofer
Sometimes, a soundbar and subwoofer may require manual pairing to establish a strong connection.
1. Begin with Power and Sync Setup: Start by powering on both Soundbar and subwoofer.
2. Press the Buttons: Based on your Polk soundbar model, hold these buttons on the soundbar and the subwoofer.
- Polk Magnfi Mini: Hold the Bluetooth and Source button on the soundbar for 3 seconds. Long-press the Sync button button for 3 seconds. A green light will flash on the subwoofer.
- Polk Signa S1 & S2: Hold the Link button on the soundbar for 3 seconds. Simultaneously, long-press the Volume Up and Bluetooth buttons on the soundbar for 5 seconds.
- Polk Magnifi Max: Hold the Sync buttons on the soundbar and subwoofer for 3 seconds. The subwoofer’s light will blink green, indicating that it is ready for pairing.
- Polk DSB1: Hold the Sync button on the soundbar for 3 seconds and plug in the soundbar. A green light will flash.
- Polk SR1 Soundbar: Hole the Sync/Connect button on the subwoofer and soundbar for 7 seconds.
When the soundbar and subwoofer are connected, the blinking light will become solid. Thus, pairing the soundbar and subwoofer is successful.
How to Fix Polk Soundbar Not Connecting to Subwoofer
If the devices aren’t connecting and frequently unpairing themselves, here are tailored troubleshooting tips.
- Firmware Check: Ensure the soundbar firmware is updated and make sure to place the soundbar near the subwoofer.
- Device Reset: Power cycle both devices by turning them off, unplugging, and waiting a few minutes before reconnecting.
- Check for Signal Interference: Remove nearby electronics that may interfere, such as routers or microwaves.
FAQ
You can connect the Polk subwoofer to the receiver using the RCA cable.
